Battery Kit Instructions - Preheat

Quick Start Guide

Carefully screw in your cartridge

Do not overtighten

Finger tighten just enough to make contact

Finger button 5 (five) times within 2 seconds to turn on

Enjoy!

Adjust Output Voltage

Click button 3 times within 2 seconds to adjust voltage

Switch light change to red 3.8V (full-power output), blue 3.4V, green 2.7V

Working time is 8 seconds

Preheating

Click button 2 times within 2 seconds to start

Click button 1 time to close preheating mode

When switch light is flashing, it is working

Switch light will be off after 15 seconds

Charging Your Pen

Battery will last for 300 re-charges approximately

First time charging, please charge for 4 hours

When switch light is white, battery is charging

When switch light flashes 20 times, then turns off, battery is fully charged (the bottom light will be lit)

Unscrew cartridge

Screw charger into battery with threaded end

Plug USB charger USB outlet or wall charger

Do not overcharge!

Do not charge everyday

Each full charge will last an average 350 puffs

Turning Your Pen Off

Click button 5 times within 2 seconds to turn off

Light will blink three times to confirm

Battery Kit Instructions - Non Preheat

Quick Start Guide

Carefully screw in your cartridge

Do not overtighten

Finger tighten just enough to make contact

Finger button 5 (five) times within 2 seconds to turn on

Enjoy!

Charging Your Pen

Battery will last for 300 re-charges approximately

First time charging, please charge for 4 hours

When switch light is white, battery is charging

When switch light flashes 20 times, then turns off, battery is fully charged (the bottom light will be lit)

Unscrew cartridge

Screw charger into battery with threaded end

Plug USB charger USB outlet or wall charger

Do not overcharge!

Do not charge everyday

Each full charge will last an average 350 puffs

Turning Your Pen Off

Click button 5 times within 2 seconds to turn off

Light will blink three times to confirm

Low Key Battery Instructions

Turning On/Off

Press power button 5 times to “On” / “Off”

Vaporizing

Keep pressing the power button after battery is turned on to vape, the LED light on the power button will turn red while button is being pressed

Folding

After done vaping, press flip button again and fold cartridge back into the unit

Charging

Pull out USB charger from left side and connect to your USB outlet or wall charger. LED light will turn to green when battery is charging

When fully charged LED light will go out. Push charger back in unit

Other Tips

Resistance of cartridge must be larger than 1.2 ohm

It’s a 3.7 volt battery and works with all  5.10 threaded cartridges

When vaping, button pushing lasts over 15 seconds, LED light will blink 10 times and battery will stop working for a while. This is because it is protecting the battery

We recommend turning unit off while not in use as to prevent accidental usage of the battery especially if carrying in a pocket or bag

Why does the oil level in my cartridge or disposable look low?

Our CCELL hardware contains more holes than other hardware, making for bigger rips and more consistent hits.

The one drawback is the oil can move into the ceramic chamber earlier, making it seem like the hardware is short-filled. It’s not — the oil is there, being stored and ready for use.

CCELL Technology Information

Where did all the oil go?

CCELL’s ceramic wick atomizers are larger than most and absorb liquids well. In fact, it’s one of the reasons they produce so much vapor! After your cartridge is filled, the ceramic atomizer inside absorbs liquid over time, priming for your use. Oil is still in the cartridge, it’s simply been absorbed within the atomizer out of view. Up to 30%* of a .5ML cartridge can be absorbed resulting in headspace.

Is your cartridge under filled?

No. Like a bag of potato chips, the air is essential for proper transport and use of the product.

Why is ceramic better?

Traditional cotton wicks are more prone to increased leaking or oil coming through the mouthpiece. With ceramic “clay” cores, you get a more consistent experience with better vapor streams. Plus, the clays are higher quality and don’t introduce any unexpected contaminants into the product.

Do your products contain potentially harmful ingredients or materials?

Mezz is committed to providing the highest quality products to our customers.

Our formulations are free of Vitamin E and our hardware has passed all heavy
metals testing.

Mezz does not use any cutting agents — just solvent-free terpene
blends and CBD Isolate that has been lab tested for heavy metals, solvents, other
contaminants.

© 2018 Climb Holdings, LLC | All Rights Reserved | email: info@mezzshop.com | phone: 844.394.6399